Faucet Repair & Installation in Frisco, TX
Drips that will not stop after a new cartridge. Kitchen faucet that swivels loose at the base. Angle stops seized shut so you cannot isolate the sink. We handle every residential faucet call in Frisco — rebuilds, replacements, and the shutoffs behind them — with parts stocked for Frisco's hard water and the fixtures found in Phillips Creek Ranch and Newman Village.
Frisco's Hard Water Is Why Your Faucet Failed
North Texas Municipal Water District serves Frisco with water in the 8-10 grain range — solidly hard. That mineral load is what eats the ceramic discs inside Delta, Moen, and Kohler cartridges within 5-7 years, why aerators clog every few months, and why the pop-up drain assembly fuses to the tailpiece. A new cartridge is often the fix, but the diagnosis has to come first — a leaking base is a different problem than a leaking spout, and we treat them as such.
Older Frisco homes still have compression-style stem faucets from the 70s and 80s. Parts are still available, but the seats often need to be re-cut, not just re-washered, and the angle stops feeding them are typically the original multi-turn valves — seized shut when you actually need them. We bring quarter-turn replacement stops on every faucet call and swap them at the same visit if yours will not close.
For full replacements we carry pull-down kitchen faucets, widespread and centerset bathroom sets, and freestanding tub fillers from the brands that hold up in Frisco water. If you have already bought the fixture, no problem — we install customer-supplied faucets with the same one-year labor warranty on our work.
Signs Your Frisco Faucet Needs Service
A slow drip wastes ~3,000 gallons a year at Frisco water rates. Most of these are one-visit fixes.
Constant drip from the spout means a failed cartridge or a scored seat. On hard-water Frisco homes, both wear together.
Too much play or a handle that fights back is a cartridge or stem issue — not the handle screw. Common on 5-10 year old Moen and Delta.
Low pressure at only the kitchen or one bath usually means a clogged aerator, a partially closed angle stop, or scale buildup in the supply.
A pressure-balance or thermostatic cartridge failing on the hot side. Especially common in tub/shower valves — an easy fix if caught early.
Water pooling at the base, not from the spout, means a failed O-ring on the swivel or a cracked deck plate. Different fix than a spout drip.
A faucet that wobbles at the deck has a failed mounting nut or a rotted-out backer washer. Left alone, it stresses the supply lines under the sink.
Diagnose, Quote, Fix, Test — in One Visit
Most faucet calls in Frisco are one-visit jobs. We diagnose first, then quote before any wrench turns.
- 1Diagnose the actual failure
A drip from the spout, a leak from the base, and a stiff handle are three different repairs. We isolate the failure — cartridge, seat, O-ring, or shutoff — before quoting.
- 2Check the angle stops
Every faucet call includes testing the shutoffs under the sink. If they will not close cleanly, we quote quarter-turn replacements at the same visit so you never lose the ability to isolate the fixture.
- 3Give you a written price
Upfront pricing before we start. Cartridge rebuilds, full replacements, and shutoff swaps are line-itemed so you see exactly what each part costs.
- 4Do the work with stocked parts
Genuine Delta, Moen, Kohler, and Pfister cartridges on the truck. For customer-supplied fixtures, we verify what you have before pulling the old one so you are not left without a working sink.
- 5Pressure test and clean up
Run the faucet at full flow hot and cold, check every joint under the sink with a paper towel, clean up the workspace, and walk you through the fix before we go.
What We See in Frisco Kitchens and Baths
Housing age predicts the failure mode.
New-build custom homes with high-end pull-down kitchen faucets — diverter failures and hard-water aerator clogs dominate.
Executive homes with widespread three-hole bath faucets — O-ring rebuilds and cartridge swaps.
1990s-2000s customs with aging Moen and Delta cartridges failing on the hot side.
55+ community — grab-bar-height fixtures and ADA faucet handles for ease of use.
New PEX-manifold builds with individual fixture shutoffs — clean isolation for faucet work.
Older Frisco stock with original brass angle stops seized shut — quarter-turn replacements at every faucet call.
What Frisco Homeowners Say
Faucets Fixed Right the First Trip
We stock genuine cartridges for Delta, Moen, Kohler, Pfister, American Standard, and Grohe on every truck, plus quarter-turn angle stops, braided supply lines, and pop-up drain assemblies. That means most Frisco faucet calls are single-visit — no parts run mid-job, no leaving you with a torn-apart sink overnight.
Every faucet repair carries a one-year labor warranty from Aqua Pure Plumbing, plus the manufacturer's warranty on parts. Master plumber licensed by the Texas State Board of Plumbing Examiners, insured and bonded, dispatching from our shop in The Colony and neighboring Frisco. Same-day for active drips and seized shutoffs.
Straight Answers, No Sales Pitch
Our Other Plumbing Services in Frisco, TX
Faucet work often uncovers failed angle stops, corroded supply lines, or a slow drain under the sink. We handle all of it in the same visit.
Electronic detection and repair — reroute options that save your flooring when possible.
Trenchless replacement for Frisco's aging clay and cast iron mains — camera first, quote in writing, minimal yard damage.
Acoustic, thermal, and pressure testing to pinpoint hidden leaks in Frisco slab and wall lines without tearing into finishes.
Licensed install, repair, and pressure-testing for Frisco homes — every line signed off to Texas code.
Full-clear service and camera confirmation, not the partial snake job that guarantees a callback.
Repair, flush, and replacement of tank units — including the attic-mounted heaters common in Frisco tract homes.
Install, service, and annual descaling — Frisco's hard water is hard on tankless units without it.
Same-day and after-hours response across Frisco for burst pipes, backups, and failed heaters.
High-pressure cleaning that clears grease, scale, and roots for a full-diameter, lasting clean.
Rebuilds, wax-ring resets, flange repairs, and full replacements — the running toilets and rocking bowls in Frisco homes.
Jam clearing, leaking-unit swaps, and quiet 3/4 HP upgrades for Frisco kitchens — same-visit install.
Need Faucet Work in Frisco?
Cartridge rebuild, full replacement, or shutoff swap — parts on the truck, price in writing.